Security System Smoke Detector in Conventional Fire Alarm System

• Customization: Available
• Type: Smoke Alarm
• Usage: Fire
• Model NO.: CSD81
• Installation Mode: Ceiling Mounted
• Certification: CE, RoHS
• Application: Home, Industry, Communication Electronic Products
• Weight: 153G
• Operating Voltage: 12 to 28 VDC
• Color: White
• Operating Voltage Rage: -10 Degree to 50 Degree
• Detection Angle: 120 Degree
• Transport Package: Carton
• Specification: 103*103*45mm
• Trademark: UV
• Origin: China
• HS Code: 8531100000
• Production Capacity: 50000/Month

Product Description

INSTALLATION AND MAINTENANCE INSTRUCTIONS


Conventional Photoelectric Smoke Sensors
SPECIFICATIONS

Operating Voltage Range	9 to 28VDC Volts Non-polarized
Standby Current	≤60µA @ 24 VDC
Maximum Alarm Current (LED on )	≤30mA @ 24 VDC
Operating Humidity Range	10% to 93% Relative Humidity, Non-condensing
Operating Temperature Range	14°F to 122°F (-10°C to50°C)
Adjustable Sensitivity	1.06±.26%FT.
Height	2.2˝ (55 mm) installed in Base
Diameter	4.0˝ (103 mm)
Weight	5.5 oz. (155 g)

INSTALLATION








 

BEFORE INSTALLING
NOTICE: This manual should be left with the owner/user of this equipment.
IMPORTANT: The detector must be tested and maintained regularly following NFPA 72 requirements. The detector should be cleaned at least once a year.
GENERAL DESCRIPTION
The device is photoelectronic detector uses a state of-the-art optical sensing chamber. This detector is designed to provide open area protection and to be used with most conventional fire alarm control panel.
Two LEDs on each detector provide local 360° visible alarm indication. They flash every 3~5 seconds indicating that power is applied and the detector is working properly. The LEDs latch on in alarm. LEDs will be off when a trouble condition exists indicating that the detector sensitivity is outside the listed limit. The alarm can be reset only by a momentary power interruption.
INSTALLATION
NOTE: All wiring must conform to applicable local codes, ordinances, and regulations.
NOTE: Verify that all detector bases are installed, that the initiating-device circuits have been tested, and that the wiring is correct.

Remove power from initiating-device circuits before installing detectors.

1. Wire the sensor base per the wiring diagram, Figure 1.
2. Install the sensor into the sensor base. Push the sensor into the base while turning it clockwise to secure it in place.
3. After all sensors have been installed, apply power to the control unit.
4. Test the sensor(s) as described in the TESTING section of this manual.
5. Notify the proper authorities that the system is in operation.










Figure 1. Wiring diagram:

Warning:Forbid connect 24VDC directly without current-limiting resistance. Otherwise, the detector would be burnt out.





Dust covers are an effective way to limit the entry of dust into smoke detector sensing chambers. However, they may not completely prevent airborne dust particles from entering the detector. Therefore, We recommends the removal of detectors before beginning construction or other dust producing activity.
Be sure to remove the dust covers from any sensors that were left in place during construction as part of returning the system to service.

TAMPER-RESISTANCE
The detector includes a tamper-resistant capability that prevents their removal from the bracket without the use of a tool.