Manual Call Point, Designed for Fire Alarm Systems and Security Alarm system.
Key Specifications/Special Features
- Available for flush or surface mounting
- Plastic film on glass
- Test key inserted from side
- Open circuit with series resistor
- Suitable for the majority of conventional fire alarm systems
-
INSTALLATION
This manual should be left with the owner/user of this equipment. The call points should be installed in a position where they will not be subjected to mechanical stresses , and where the temperature is within the operating temperature range. Areas where there are , or are likely to be, aggressive substances should be avoided .
O ACTIVATE ALARM
The conventional manual call point designed for conventional fire alarm system for reporting fire or emergency condition by its button latches. The call point has one 300 ohm resistor is used on the PCB board between Zone+ and Zone- or one relay contact (NO, COM, NC ) output when the button is pressed.
|
SPECIFICATIONS
Operating Voltage Range: 9~32VDC Volts Nominal Operating Resistance: 300Ω Relay Contact Ratings: 2A/30VDC Operating Humidity Range: 95% RH, Non-condensing Operating Temperature Range: -10°C to 50°C (14°F to 122°F) Dimensions: W89mm ,H93mm, D26mm Base Dimensions: W87mm ,H87mm, D31.5mm Weight: Net Weight 125g (with base) Colour/Case Material: Red/ ABS
|
){kind=link}
){kind=link}