Addressable Fire Alarm System DC 24V Alarm Strobe Siren Loud Sounder with Flash Light

• Customization: Available
• Type: Smoke Alarm
• Signal Transmission: Wired Alarm
• Model NO.: SG6008
• Working Mode: Passive
• Application: Indoor, Outdoor
• Working Principle: Electro-Optical Type
• Transmission Mode: Cable
• Alarm Volume (within 1m): ≥80dB
• Receive Frequency: Alarm System
• Coclor: Red
• Power: DC6V to 27V
• Volume at 24V and 3m: 75dB-110dB
• Wiring Method: Two-Wire Bus (Non-Polarized)
• Operating Current(Min): 5mA
• Transport Package: Carton
• Specification: 100*45.5mm
• Trademark: Alarm
• Origin: China
• HS Code: 8531100000
• Production Capacity: 50000/Momth

Product Description

Features

• Ultra low power consumption with non-polarized two wire bus.
• Professional microchip provides highest reliability.
• Adopt super bright LED and special structure buzzer to achieve high luminance and high sound pressure.
• Visual or audible visual mode setting freely.
• Each detector has a unique detector ID at the back.
• Electrically addressed, can be modified online or by a programmer.
• Chute designed to ease installation.

Technical Specifications

Operating Voltage Range	DC6V to 27V
Monitoring Current(Max)	0.2mA
Operating Current(Min)	5mA
Volume at 24V and 3m	75dB-110dB
Change cycle	2.Os-4.Os
Flash rate Maximum loop length Temperature Range Humidity	1.0Hz -1.5Hz 5km (based on ZR-RVS-2*1.5mm^2) -10 °C ~+55 °C <95% rel. (non-condensing)
Sensor Base	J-SCM08
Protection Category	IP30
Dimensions( XH)	100.0x45.5mm (including base)

Wiring method two-wire bus (non-polarized)

Installation
Surface mounted, in the normal space, height 2.2m above the ground is appropriate.

• Fix the base  (determine the installation direction according to the mark T") on the embedded junction box or the mounting location with the M4 screw.
• Adopt ZR-RVS-2*1.5mm² twisted pair to respectively run through the entrance holes in the base and polarity-indiscriminately connect to the S+ and S- terminals.
• Set address (1 to 200) on the detector by programmer.
• Install the VAD on the base.

Wiring
"S+" and "S." are the bus terminals connected to the Fire alarm control Panel(F.A.C.P.).